Progressive-industries EMS-PT30C Bedienungsanleitung PDF herunterladen (Seite 4)

Operating Instructions

1. Plug into AC power.

2. Digital display will read 888 for one second then begin

scrolling the voltage, amps, line frequency, and error

code(s). In addition, the time delay light will flash in the

bottom right corner of the display.

3. The EMS will read a 3-digit number which is your line

voltage. Next, it will give you a “0A” reading. This is the

amp reading; however, it will read zero until the time delay

is complete. Then you will notice a number between 0 and

30. That number indicates how many amps the RV is

drawing. Next, you will notice a number of 60 H which is

your line frequency. That number should remain fairly

consistent, however it may read plus/minus one or two.

Lastly, you will notice the E code; E-0 is normal. Only

when E-0 and E10 is present will the delay light flash and

ultimately bring power to the RV. Refer to your Error

Code Chart that was provided or see the next page for

details.

4. Verify that Error Code E0 is displayed.

5. Set up is complete.

6. The EMS has a 136-second time delay before you will

receive power into your RV.

Important: The display will only read voltages between 78 volts

and 255 volts.

NOTE: If the wiring reads anything different than correct, the

EMS will not turn on and we recommend moving to a different

source of AC power or use your generator power. Also, if power

is below 104 volts or above 132 volts the EMS will not turn on,

and we recommend using your

generator power.

1 2 3 4 5 6 7

Keine Kommentare

Progressive-industries EMS-PT30C Bedienungsanleitung Seite 4